ANCEL FX2000 Upgrade Guide
A software update is required if you encounter the following problems:
1. The tool fails to work on your car.
2. It is slow to load all menus.
3. You need newer software version.
The tool can be updated only via the memory card.
Follow the steps below to proceed the update:
Note: Please prepare a computer with Windows 7/ Windows 8/ Windows 10 installed and
make sure it is successfully connected to the Internet. Moreover, a memory card reader is
also needed.
1.
Connect the tool to the computer via the supplied data cable.
2.
After the tool is powered on, place cursor on the Help icon and press the [OK]
button. (Figure 7-1)
Figure 7-1
3.
Select [Tool Information], press [OK]. (Figure 7-2)
To Next Page
Need help?
General
