4.4.2 Electronic Parking Brake
Select [Special Functions] and select [Electronic Parking Brake],
it is displayed as follows:
Follow the prompts. Since there are many steps, we have only
shown part of the operation.
Select Function
Electronic Parking Brake
Throttle/ldle Speed
Power train
Tire Pressure Monitorin S stem
Exhaust Emission
Steering
2/14
Operator Message
Note!
During The Procedure, The
Engine Shall Be Off,And The
Supply Voltage Shall Be 12.5V
(standard) .if The Voltage Is Less
Than The Standard, Then The
0K
Operator Message
The Following Routine Will
Release The Parking Brake
Cables To A Service Position
Suitable For Replacing The Brake
Pads Or Parking Brake Cables.
Release The Parking Brake
0K ESC
EN
Select Function
ic Parking Brak
Ignition State
ar
Set The Ignition Switch To
On(position 2)
0K
Operator Message
On Completion Of The Work,
The Parking Brake Will Need To
Be Recalibrated.
To Perform The Calibration.
Make Sure The Ignition Is On.
Depress The Footbrake And Pull
0K
11
To Next Page
Loading...
