ANCHEER
11
Installation And Adjustment
3. Install the controller and battery
Loosen the screws used to fix the controller on the rear rack, then place the
controller on the front of the rear rack, re-fix the screws and tighten them.
Push the battery along the
slide, and connect it with
the controller.
The controller and battery should be
connected tightly.
Note:
3.2
3.1
3.3
After completing the installation, you can turn on the switch on the battery, and
press the "M" button on the meter to see if the indicator lights of the meter is on to
confirm whether the controller and the battery are properly connected.
To Next Page
Loading...
