Need help?Do you have a question about the ANDERSON-NEGELE ILM-4 and is the answer not in the manual?
General| Measuring Principle | Conductive |
|---|---|
| Accuracy | ±1% of measured value |
| Temperature Range | -10 - 130 °C |
| Temperature Compensation | Automatic |
| Pressure Range | Up to 16 bar |
| Material | PEEK |
| Output Signal | 4-20 mA |
| Operating Temperature | -20…60 °C (-4…140 °F) |
Notes on the proper installation of the device in pipes to ensure correct measurement and avoid air bubbles.
Conditions for hygienic installation according to 3A and EHEDG standards, including temperature limits and self-draining properties.
Guide to creating custom concentration curves using the MPI-200 software by defining conductivity (X) and concentration (Y) points.
Step-by-step guide on how to set the conductivity 1 measurement range using the sensor's display interface.
Instructions for installing a large user interface display on a sensor that did not have a display previously.
Procedure to replace a small display unit (SUI) with a large user interface display (LUI) using a puck puller tool.
To Next Page
