Need help?Do you have a question about the ANDERSON-NEGELE ITM-51 and is the answer not in the manual?
General| Measuring range | 0.05...10 m/s (1.6...32.8 ft/s) |
|---|---|
| Protection class | IP67 |
| Protection Rating | IP67 |
| Output signal | 4-20 mA |
| Materials | 1.4404/316L, PEEK |
| Resolution | 0.01 |
| Output | 4-20 mA, HART |
| Power Supply | 12...30 VDC |
| Housing Material | Stainless steel |
| Operating Temperature | -40 to 70°C (-40 to 158°F) |
Notes on mechanical connection and installation for optimal sensor placement.
Guidance on hygienic installation practices according to 3A and EHEDG standards.
Instructions for configuring the sensor using the MPI-200 programming adapter.
Guide to configuring the sensor via its integrated user interface.
Illustrative examples of common sensor parameter configurations.
Steps to install the large display when no display was previously fitted.
Procedure to replace a small display with a large display.
Instructions for operating the large user interface display unit.
To Next Page
