4
DANGER: Improper use of the grounding plug can result in a risk of
electric shock. If repair or replacement of the cord or plug is necessary, do not
connect the grounding wire to either flat-blade terminal. The wire with insulation
with an outer surface that is green (with or without yellow stripes) is the grounding
wire. Check with a qualified electrician if you do not completely understand these
grounding instructions, or if in doubt as to whether the appliance is properly
grounded. Do not modify the plug provided; if it will not fit the outlet, have the
proper outlet installed by a qualified electrician. This appliance is for use on a
nominal 120-volt circuit, and has a grounding plug (Figure A). A temporary adapter
(Figures B & C) may be used to connect this plug to a 2-pole receptacle (Figure B)
if a properly grounded outlet is not available. The temporary adapter should be
used only until a properly grounded outlet (Figure A) can be installed by a qualified
electrician. The green colored rigid ear, lug, or similar extending from the adapter
must be connected to a permanent ground such as a properly grounded outlet-box
cover. Whenever the adapter is used, it must be held in place by a metal screw.
OPERATING INSTRUCTIONS
Before starting clipper, remove blade guard (some models may not have a blade
guard). Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical
current or as noted on the unit. To start clipper, move switch button to ON position.
To stop clipper, move switch button back to original position. After using your clipper,
rewrap cord and store in a safe place.
USING ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a coarser cut by attaching any of the snap-on attachment
combs made for your clipper. The attachment combs mount easily–they snap on and
off (Figures D & E). These attachment combs guide hair into the clipper blades and
give you precise control of hair lengths. The length of trim is indicated on the comb.
Different blade angles in relation to the skin, thickness and texture of the hair will
vary the cutting length. Use the chart to find the approximate lengths of cut.
To Next Page
Loading...
Need help?
General
