Need help?Do you have a question about the andrews CSC59 and is the answer not in the manual?
Information about the heater's intended use, installation, and compliance with regulations.
Lists relevant British Standards and Codes of Practice for installation and operation.
Discusses legal requirements for safe operation and installation under specific regulations.
Explains the heater's resistance to Legionellae bacteria growth and the study conducted.
Provides detailed specifications and required clearances for various models.
States the legal requirement for installation by qualified personnel and compliance with regulations.
Details requirements for selecting a suitable installation location, clearances, and safety.
Explains natural gas supply connection, safety, and components.
Details propane/butane supply requirements, including cylinder configurations.
Outlines mains electricity connection requirements, fuse ratings, and isolation.
Describes the direct fan flued system, installation warnings, and terminal requirements.
Details installation procedures for flue terminals and components, including maximum lengths.
Specifies requirements for air vents and ventilation in compartments and rooms.
Discusses scale formation, magnesium anodes, and water treatment recommendations.
Details water connections for vented systems, safety valves, and pipework.
Outlines requirements for unvented systems, pressure limits, and system kits.
Step-by-step guide for filling the water heater with water before operation.
Instructions on how to safely drain the water from the heater.
Procedures for safely lighting the burner and checking gas connections.
Guidance on how to shut down the burner for short and long periods.
Steps for checking and adjusting the main burner pressure.
How to visually inspect and assess the pilot and main burner flames.
Essential safety information and warnings for users before operating the appliance.
Describes the step-by-step process of the heater's operation when activated.
Explains the function and operation of the Energy Cut-Off (ECO) device.
Discusses the phenomenon of temperature stratification and its mitigation.
General advice on servicing, emphasizing qualified personnel and annual checks.
Essential steps to take before performing any servicing on the heater.
Details annual checks required for ignition systems, controls, and combustion seals.
Specifies lubrication requirements for blower motor bearings every six months.
Provides instructions on how to remove and re-install the burner rack assembly for cleaning.
Guidance on checking and cleaning the gas control valve and its filter.
Explains the function, inspection, and replacement of magnesium sacrificial anodes.
Instructions for checking the condition and operation of the relief valve.
Details how to check, clean, and descale the storage vessel, including warnings.
Troubleshooting steps for when the heater fails to produce hot water.
Diagnosing and resolving issues related to sooting and poor burner combustion.
Troubleshooting steps for excessive water temperatures.
Addresses issues of insufficient hot water supply relative to demand.
Identifies causes and solutions for water dripping from the heater's base.
Explains causes of rumbling noise, often related to scale, and solutions.
Troubleshooting for issues with continuous ignition or no pilot flame.
Steps to diagnose why the pilot lights but the main burner does not ignite.
Troubleshooting for failure of the pilot to ignite.
Lists parts with reference numbers and quantities, accompanied by diagrams.
General| Brand | andrews |
|---|---|
| Model | CSC59 |
| Category | Water Heater |
| Language | English |
To Next Page
