1. Choose a location for your waterfall spillway, it can sit inside
the liner or at the liner perimeter. Most of the time it is placed
at the beginning of a stream. The important thing to remember
is that all of the water coming out of the filter must stay within
the pond liner to avoid water loss. Fig. 1
Fig. 1
2. Place the tank in the place that you prepared for it and check
that it is level before burying. Fig. 2
Fig. 2
3. Make sure to lay your liner into position and check for any
wrinkles or pulling on the liner. Once you are confident the
liner will fit just right, carefully clean and rinse both sides of
the liner and dry it off with paper towels or a clean cloth. The
surface must be clean and dry for the sealer to bond properly.
Mark the liner with the shape of the spillway. White or yellow
markers are recommended. Fig. 3
Fig. 3
Waterfall returning directly to pond
PLEASE CALL 1-800-553-5605 BEFORE RETURNING TO THE STORE.
WWW.ANJONMFG.COM
To Next Page
Loading...