EN 8483 EN
Installation
1. Connect the solar panel with the solar panel extension cable.
2. Select an appropriate location to install the microinverter.
Note: The microinverter's front surface (with the Anker logo) should face outwards.
The microinverter can be installed with the stainless steel hose clamp and nuts.*
*The stainless steel hose clamps and nuts are not included in the package.
3. Install another solar panel.
4. Connect the solar panel and the microinverter with the solar panel extension cables.
Note:
1. Ensure that two solar panels have been installed before this step.
2. This step must be done while there is enough sunlight for the solar panel to provide power to the microinverter.
To Next Page
Loading...
