9
Li
a35
r
a u
Lo
Err
1.
2.
WARNING!
Button cell batteries can
3u
.....ttr
6
iim
cause serious injury or
death if swallowed.
t*
Dispose of safely!
Store batteries out of
reach of children!
visit
TheBatteryControlled.com.au
WARNING!
The battery must be installed by an Adult. Keep batteries out of reach of
young children.
anko
LECTRONIC
CHEN SCALES
STRUCTIONS FOR USE
•
"ZERO" OR "TARE" FUNCTION
To weigh different loads consecutively without removing loads from the scale.Put first
load on the scale, get weight reading. Press
button to reset the LCD reading
to "0" before adding next load. You can repeat this operation.
•
Condition 1: "ZERO" function
When total sum of all loads on scale
•
-c...4% of scale's max.weight capacity.
(4%=80g when capacity is 2kg;
200g when capacity is 5kg)
LCD will show "—" or "Og" each time
is pressed. "---" means not stable, please
wait for a moment. "Og" and meanwhile an
icon "o" on the left of LCD mean "ZERO"
function is active. Max.weight capacity remains
unchanged.
III AUTO SHUT OFF
Auto shut-off occurs if display shows 'O'or shows
the same weight reading for 1 minute.
•
WARNING INDICATORS
1.
Replace new battery.
2.
Scale overload. Remove item to avoid damage.
Max.weight capacity is indicated on the scale.
A CLEANING AND CARE
1.
Clean the scale with a slightly damp cloth. DO NOT immerse the scale
in water or use chemical / abrasive cleaning agents.
2.
All plastic parts should be cleaned immediately after contact with fats,
spices, vinegar and strongly flavored / colored foods. Avoid contact with
acids citrus juices.
3.
Always use the scale on a hard, flat surface. DO NOT use on carpet.
4.
DO NOT strike,shake or drop the scale.
5.
The scale is high precision device.Please take care of it.
6.
Please keep it dry.
7.
Please check whether battery is installed or in high level if scale can not
be turned on.
8.
The scale is for family use only, not for commerical purpose.
•
Condition 2: "TARE" function
When total sum of all loads on scale
> 4% of scale's max.weight capacity.
(4%=80g when capacity is 2kg;
200g when capacity is 5kg)
LCD will show "—" or "Og" each time
is pressed. "----" means not stable, please
wait for a moment. "Og" and meanwhile an
icon "T" on upper left corner of LCD mean
"TARE" function is active. Max. Weight capacity
is reduced by total weight of all loads.
•
Under this condition:
By pressing
, you can see the total
weight of all loads on the scale. If you want
to weigh more loads, just press
reset LED reading to '0' again.
9CE
42616450
6
5
To Next Page
Need help?
General
