LCD will show “-----” or “0g” each time is pressed.
“-----” means not stable, please wait for a moment. “0g”
and meanwhile an icon on upper left corner of LCD mean
“TARE” function is active. Max. capacity is reduced by total
weight of all loads.
65
"ZERO" OR "TARE" FUNCTION
To weigh different loads consecutively without removing loads from the scale.Put first load on the scale,
get weight reading. Press button to reset the LCD reading to "0" before adding next load.
You can repeat this operation.
Condition 1: "ZERO" function
When total sum of all loads on scale≤4%
Condition 2: "TARE" function
When total sum of all loads on scale＞4%
LCD will show “-----” or “0g” each time is pressed.
“-----” means not stable, please wait for a moment. “0g” and
meanwhile an icon on upper left corner of LCD mean “ZERO”
function is active. Max. capacity remains unchanged.
UNIT AND MODE SETTING
If the scale is with both measuring systems of Metric (g,kg) and Imperial (oz,lb), you can press "unit"
convert between two systems during the course of weighing:
1. Press shortly to convert weight unit between Metric and Imperial systems.
2. Press for 3 seconds to enter mode setting and convert between weighing mode and
volume mode (water or milk).
Press shortly
Metric system:
Press
for 3 seconds
Press
shortly
Press
shortly
Press
shortly
Press
for 3 seconds
Press
shortly
Press
shortly
Press
shortly
Imperial system:
Remark: The unit system of scale depends on sales destination or the requirement of distributor.
TO CHANGE BETWEEN WEIGHING MODE
AND REAL TIME DISPLAY MODE
120s
Idle for 120 seconds
To Previous Page
Loading...
