anko CM5013-SA - Important Safeguards

IMPORTANT SAFEGUARDS
Before using the electrical appliance, the following basic precautions should always be followed
including the following:
1. Read all instructions.
2. Before using check that the voltage of wall outlet corresponds to rated voltage
marked on the ratin
g
plate.
3. This appliance has been incorporated with a grounded plug. Please ensure the
mains power outlet in
y
our house is well earthed. If unsure consult an electrician.
4. To protect against fire, electric shock and injury to persons do not immerse main
parts of the product, cord, plu
g
, in water or other liquid.
5. The appliance must not be immersed.
6. Remove the plug from mains power outlet socket before cleaning and when not in
use. Allow appliance cool down completel
y
before takin
g
off, attachin
g
components
or before cleanin
g
.
7. If the supply cord is damaged DO NOT use. Any repairs to the product must be
carried out b
y
qualified electrical person onl
y
or the product must be disposed.
8. The use of accessory attachments not recommended by the appliance
manufacturer ma
y
result in fire, electric shock or in
j
ur
y
to persons.
9. Place appliance on a flat surface or table, do not hang the power cord over the edge
of table or counter.
10. Ensure the power cord do not touch hot surfaces of appliance.
11. Do not place the espresso machine on hot surface or near any heat source. i.e.
stove.
12. To disconnect, remove plug from wall outlet. Always hold the plug. But never pull
the cord.
13. Do not use appliance for other than intended use and place it in a dry environment.
14. Be careful not to get burned by the steam.
15. Do not touch the hot surfaces on appliance (such as steam wand, and the steel
mesh when boilin
g)
. Use handle or knobs.
16. Do not let the coffee maker operate without water.
17. DO NOT remove the metal funnel while brewing coffee. Please remove the metal
funnel to make additional coffee after finish brewin
g
for more than 10 seconds.
Caution should also be taken while removin
g
the metal funnel since the metal parts
will be hot. Please make sure to hold it b
y
the handle and to use the filter retention
clip t o dispose the
g
rounds.