To Next PageTo Next Page
Need help?Do you have a question about the anko EB6013A and is the answer not in the manual?
Users must read and keep these instructions for future reference before operating the appliance.
Appliance not for persons with reduced capabilities without supervision; children must be supervised.
A damaged supply cord must be replaced by qualified persons to avoid hazards.
Caution is advised to avoid injuries from the egg pricker.
The heating element surface remains hot after use.
Misuse according to the manual can cause electric shock or other hazards.
Appliance is for household and similar applications like kitchen areas and farm houses.
Do not immerse any part of the appliance or cord in water or other liquids.
Always use the appliance on a dry, clean, stable, and level surface.
Only use the appliance for its intended purpose and indoors.
Always disconnect from mains power outlet when not in use and before cleaning.
Never start the appliance without filling water into the cooking tray.
Do not operate the appliance if it is damaged or malfunctioning.
Do not let the cord hang over edges or touch hot surfaces; do not move during operation.
Avoid scalding from hot water; do not move the appliance while it contains hot water.
Care must be taken not to touch any hot surfaces.
Do not place near hot gas or electric burners, ovens, or microwaves.
Do not use harsh abrasives, caustic cleaners, or oven cleaners.
Allow the appliance to cool down in a safe place before cleaning.
The appliance is not designed for commercial purposes.
Lay egg pricker protector safely; do not allow children to play with it.
Never attempt to repair the appliance yourself; use qualified personnel.
Appliance becomes very hot; do not remove top cover until buzzer sounds.
Unwind cord and place appliance on a level surface for proper operation.
Measure water using the cup based on egg quantity and desired hardness levels.
Pierce eggs at the dull side with the egg pricker to prevent bursting.
Place eggs on holder, then place holder in tray, and secure the top cover.
Insert plug, turn knob to 'ON'; indicator lights up, and boiling begins.
Use 'KEEP WARM' position for up to 20 minutes to prevent eggs from getting cold.
Always turn power off and allow the egg boiler to cool before cleaning.
Clean the heating plate with a damp cloth; use diluted vinegar for calcium deposits.
Clean the stainless steel cooking tray with a special agent for residues.
Wipe the outside with a damp cloth and polish with a soft dry cloth.
This document outlines the features, usage, and maintenance of the Anko Egg Boiler, Model EB6013A, a household appliance designed for cooking eggs.
The Anko Egg Boiler is an electrical appliance specifically designed to boil eggs to various degrees of hardness. It operates by heating water in a cooking tray, generating steam that cooks the eggs placed in an egg holder. The device includes a switch knob for controlling operation, an indicator light, and a measuring cup with an integrated egg pricker to ensure proper cooking and prevent eggs from cracking.
Before operation, users must read and retain the instructions for future reference. The appliance is intended for household and similar applications, such as staff kitchen areas, farmhouses, hotels, motels, and bed and breakfast environments. It is not designed for commercial purposes.
To use the egg boiler, first, unwind the power cord and place the appliance on a dry, clean, stable, and level surface to ensure even cooking. The measuring cup provided is crucial for determining the correct amount of water needed, which varies based on the number of eggs (1-6) and the desired hardness (soft, medium, or hard). The measuring cup has distinct markings for each hardness level. Users should fill the cup with clear, cold water up to the appropriate marking and then pour this water into the cooking tray.
Before placing eggs in the holder, it is essential to pierce the dull side of each egg using the egg pricker located at the bottom of the measuring cup. This step is critical to prevent the eggs from bursting during cooking. After piercing, place the egg holder onto the cooking tray, ensuring the blunt end of the egg(s) points upwards. The top cover must then be placed securely on the egg holder before switching on the appliance.
Once the setup is complete, insert the supply cord plug into a mains power outlet socket. Rotate the switch knob to the "ON" position. The indicator light will illuminate, signaling that the boiling procedure has commenced. The appliance will automatically switch off, and a buzzer will sound when the eggs are cooked to the desired hardness. At this point, the user should rotate the knob switch to the "OFF" position.
When removing the egg holder and top cover, it is important to use the handles on the sides, as hot steam may escape. The top cover should be tilted slightly to allow condensation to drip. The egg holder should be placed on a flat surface, and the cooked eggs should be removed and placed under cold water to prevent further cooking and fermentation.
For users who do not wish to consume the eggs immediately, the switch knob can be turned to the "KEEP WARM" position after cooking. This feature helps maintain the eggs' warmth for a limited period, not exceeding 20 minutes, to avoid affecting their taste. After the keep-warm period, the knob should be turned to "OFF," and the eggs removed as described above.
Several safety warnings are highlighted. Hot steam escapes from the steam outlet during operation, posing a scalding risk. Users must exercise caution when using the needle of the egg pricker to avoid injury. The appliance should be kept out of reach of children and infirm persons. A cautionary symbol for hot surfaces indicates areas that can cause scalding, and these surfaces should not be touched. The appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised or instructed by a responsible person. Children must be supervised to ensure they do not play with the appliance.
The supply cord, if damaged, must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid hazards. The egg pricker protector should be kept in a safe place, away from children, to prevent accidental ingestion. Never attempt to repair the appliance oneself; all repairs must be carried out by a qualified electrical person. The appliance becomes very hot during operation, and the top cover should not be removed until the buzzer sounds.
The appliance should always be disconnected from the mains power outlet when not in use and before cleaning. It should never be started without water in the cooking tray. Do not operate the appliance if it is damaged or has malfunctioned. The cord should not hang over the edge of a table or counter or touch hot surfaces. The appliance should not be moved, nor should the cord be pulled during operation. To avoid scalding, do not move the appliance while it still contains hot water. Care must be taken not to touch hot surfaces, and the appliance should not be stored or covered until it has fully cooled down. The appliance should not be placed on or near a hot gas or electric burner, or where it could touch a heated oven or microwave oven.
Proper care and cleaning are essential for the longevity and safe operation of the egg boiler. Always turn the power OFF and disconnect the appliance from the mains power supply, allowing it to cool completely before cleaning.
After use, once the appliance has cooled down, the heating plate should be cleaned with a damp cloth. For calcium deposits, diluted vinegar can be used for approximately 30 minutes, followed by careful rinsing of the cooking plate. Harsh abrasives, caustic cleaners, or oven cleaners should not be used, as they can damage the appliance. Only a soft cloth and a mild detergent should be used for cleaning to prevent damage.
The cooking tray is made from rust-resistant stainless steel. Any iron molds that appear are typically residues sticking to the surface and should be removed with a special cleansing agent designed for stainless steel. The exterior of the egg boiler can be wiped with a slightly dampened cloth and polished with a soft dry cloth. It is crucial not to immerse the unit in water or any other liquid to prevent electrical shock and damage.
The appliance should be allowed to cool down in a safe, child-inaccessible place before cleaning.
General| Model | EB6013A |
|---|---|
| Type | Egg Cooker |
| Capacity | 7 eggs |
| Power | 360W |
| Material | Plastic |
| Indicator Light | Yes |
| Auto Shut-off | Yes |
| Voltage | 220-240V |
| Frequency | 50/60Hz |
| Water measuring cup | Yes |
| Poaching tray | Yes |
