anko HF1209-SA - Technical Specifications; Troubleshooting Common Problems

7
TECHNICAL DATA
MODEL
POWER SUPPLY
POWER
CAPACITY
HF1209-SA
220-240V 50-60Hz
26W
3.7L
TROUBLESHOOTING
Some problems may be caused by minor faults that you can be corrected yourself. To do so,
follow the instructions in the following table. If it is still not possible to resolve the problem,
contact Kmart customer service. Do not attempt to repair the humidifier yourself.
Problem
Possible cause
Solution
Power Light is off/ No
mist from spout.
• Unit is not plugged in.
• No power at outlet.
• Low water level.
• Timer function activated.
• Plug the unit to mains supply,
press the POWER button
to turn the power ON.
• Check circuits and fuses or
try a different mains power
outlet.
• Refill tank with water.
• Timer function may have
been set and caused
the unit to turn off.
Peculiar Odour
• If this is a new unit.
• If unit is in use, the odour
may be a dirty tank or old
water in the tank.
• Open the water tank cap
and keep it in a shady and
cool place for 12 hours.
• Empty the old water, clean
the tank and fill it with clean
fresh water.
Excessive Noise
• Unit is not level.
• Low water level.
• Place unit on a flat, even
Surface.
• Refill the tank with fresh
water.
White Dust Accumulation
• Hard water used.
• Use distilled water.
• Clean the water tank, use a
soft brush to remove any
residue.