7
YOUR FLAME EFFECT ELECTRIC HEATER
Congratulations on the purchase of your new Heater. Before
using your new heater, it is important that you read and follow the
instructions in this Use and Care booklet, even if you feel that you
are quite familiar with this appliance. Find a place to keep this
booklet handy for future reference. Attention is drawn to section
dealing with ‘IMPORTANT SAFEGUARDS.’
This appliance has been designed to operate from a standard
domestic power outlet. It is not intended for industrial or
commercial use.
ASSEMBLY
Before using the heater, the feet (supplied separately in the
carton), must be fitted to the unit. These are to be attached to the
base of the heater using the screws provided and with the
aid of an Phillips head hand screwdriver ( Not supplied ),taking
care to ensure that they are located correctly and that holes in
plastic feet align with the pilot holes in base of the heater as
shown in illustration below.
Note: The screws needed for the fitting of the feet are enclosed in the
plastic bag containing the heater Instruction booklet.
COMPONENTS
1X Heater body
4X Sturdy stable foot
16X Screw ST 4X18 mm
To Next Page
Loading...