To Next PageTo Next Page
Need help?Do you have a question about the Annovi Reverberi AR 252 and is the answer not in the manual?
Operating instructions for the AR252 control unit, covering startup and spraying modes.
Procedure to set the control unit to full bypass for pump priming.
How to set the control unit for spraying by rotating the red knob to position 'A'.
Specifies the pump's intended application in agricultural spraying machinery.
Lists liquids and environments to avoid when operating the pump.
Emphasizes maintaining safety devices like guards and relief valves.
Acknowledges inherent risks that persist even with safety compliance.
A simplified illustration of a typical pump installation layout.
Rules for connecting the pump to water sources, including head and vacuum limits.
Guidelines for safe lifting, loading, and handling operations.
Information on pump packaging and procedures for unpacking.
Recommendations for securing the pump during transportation.
Advice on storing the pump when not in use.
Precautions for safe and risk-free installation of the pump.
Details on crankshaft rotation, water connections, intake filters, and pressure ratings.
Guidelines on pump installation angle and securing the pump base.
Essential safety checks and precautions before operating the pump.
Steps to perform before putting the pump into operation.
Detailed procedure for safely starting and stopping the pump.
Crucial safety advice before performing any maintenance work.
Lists recommended lubricants for the pump and their specifications.
Instructions for checking and tightening pump fixing screws.
Guidance on checking for leaks and inspecting hoses for wear.
Procedure for inspecting and cleaning the inlet filter cartridge.
Steps to check and top up the pump's oil level using the sight glass.
How to check and adjust the inflation pressure of the accumulator.
Procedures for flushing and storing the pump to prevent damage.
Checks required before recommissioning the pump after storage.
Guidelines for the proper disposal of used pump units.
General| Type | Diaphragm Pump |
|---|---|
| Max Pressure | 2.5 MPa (25 bar) |
| RPM | 1450 RPM |
| Pump Material | Aluminum |
| Max Flow | 20 L/min |
| Power | 0.75 kW |
| Max Flow Rate | 20 L/min |
| Motor Power | 0.75 kW |
