Anritsu Site Master S114C - Chapter 3 - Getting Started; Introduction; Power on Procedure

Chapter 3
Getting Started
Introduction
This chapter provides a brief overview of the Anritsu Site Master. The intent of this chapter
is to provide the user with a starting point for making basic Return Loss and Spectrum Ana
-
lyzer measurements. Procedures that are specific to Site Master mode (page 3-2), Spectrum
Analyzer mode (page 3-9), and common to both modes (page 3-12) are presented.
Power On Procedure
The Anritsu Site Master is capable of up to 2.5 hours of continuous operation from a fully
charged, field-replaceable battery. Built-in energy conservation features allow battery life to
be extended over an eight-hour workday.
The Site Master can also be operated from a 12.5 Vdc source (which will also simulta
-
neously charge the battery). This can be achieved with either the Anritsu AC-DC Adapter
(P/N 40-115) or 12.5 Vdc Automotive Cigarette Lighter Adapter (P/N 806-62). Both items
are included as standard accessories (see Chapter 1).
To power on the Site Master:
Step 1.
Press the ON/OFF front panel key (Figure 3-1).
The Site Master will display the model number, the firmware revision, the tem
-
perature and voltage, and then perform a five second self-test. At completion of
the self-test, the screen displays a prompt to press ENTER to continue. If enter
is not pressed, the Site Master will continue after a 5 second timeout:
Step 2.
Press ENTER to continue.
The Site Master is now ready for operation.
3-1
3
HOLD
RUN
START
CAL
AUTO
SCALE
SAVE
SETUP
RECALL
SETUP
LIMIT
MARKER
SAVE
DISPLAY
RECALL
DISPLAY
PRINT
MODE FREQ/DIST
AMPLITUDE
SWEEP
SYS
ENTER
CLEAR
ESCAPE
ON
OFF
/
1
2
4
5
6
7
8
9
0
3
+
-
.
Site Master S332C
ON/OFF
KEY
Figure 3-1. Site Master On/Off Key