therefore should not be interpreted as a problem with the
device.
Heed service markings
Except as explained elsewhere in the Operating or
Service documentation, do not service any product
yourself. Service needed on components inside the
device should be done by an authorized service
technician or provider.
Protect your phone
• Always treat your phone and its accessories with care
and keep them in a clean and dust-free place.
• Do not expose your phone or its accessories to open
flames or lit tobacco products.
• Do not expose your phone or its accessories to liquid,
moisture or high humidity.
• Do not drop, throw or try to bend your phone or its
accessories.
• Do not use harsh chemicals, cleaning solvents, or
aerosols to clean the device or its accessories.
• Do not paint your phone or its accessories.
• Do not attempt to disassemble your phone or its
accessories, only authorized personnel must do so.
• Do not expose your phone or its accessories to
extreme temperatures, minimum -4°F (-20°C)
and maximum 122°F (50°C).
• Please check local regulations for disposal of electronic
products.
• Do not carry your phone in your back pocket as it
could break when you sit down. Damage requiring
service
Unplug the product from the electrical outlet and refer
servicing to an authorized service technician or
provider under the following conditions:
• Liquid has been spilled or an object has fallen into the
product.
• The product has been exposed to rain or water.
• The product has been dropped or damaged.
• There are noticeable signs of overheating.
• The product does not operate normally when you
follow the operating instructions.
Avoid hot areas
The product should be placed away from heat sources
such as radiators, heat registers, stoves, or other
products (including amplifiers) that produce heat.
Avoid wet areas
Never use the product in a wet location.
Avoid using your device after a dramatic change in
temperature
When you move your device between environments
with very different temperature and/or humidity
ranges, condensation may form on or within the
device. To avoid damaging the device, allow sufficient
time for the moisture to evaporate before using the
device.
NOTICE: When taking the device from low-
temperature conditions into a warmer environment or
from high-temperature conditions into a cooler
environment, allow the device to acclimate to room
temperature before turning on power.
Avoid pushing objects into product
Never push objects of any kind into cabinet slots
or other openings in the product. Slots and
openings are provided for ventilation. These
openings must not be blocked or covered.
To Next Page
Loading...
