Anslut 006248 - Time Display Modes; Setting the Weekday and Time; Setting the Weekday; Setting the Time

EN
13
∧+
Press ∧+ to increase the value when setting
programme, time or weekday.
∨–
Press ∨– to decrease the value when setting
programme, time or weekday.
S
Press at the same time CLOCK and ∨– to switch
to summertime. The time is set automatically
forward 1 hour and S is shown in the display.
RESET
PressRESET once to reset all programme
settings. If the display is empty, plug the timer
into a power point and press RESET.
TIME DISPLAYING
The time can be shown with 12 or 24 hour
displaying
1. 12 hour displaying: The digits 00:00 to
12:00 are shown in the display together
med AM or PM.
2. 24 hour displaying: The digits 00:00 to
23:59 are shown in the display (AM/PM
not shown).
3. To switch between 12 and 24 hour
displaying, press CLOCK until the display
changes. Press CLOCK again to return to
the original display mode.
NOTE:
The timer battery is fully charged when the
timer has been plugged into a power point
for two hours. If the display is empty, plug
the timer into a power point and press RESET.
SETTING THE WEEKDAY AND TIME
Setting the weekday
1. Press SET until the weekday starts to ash.
2. Press ∧+ to increase the value,
or ∨– to decrease the value as per:
MoTuWeThFrSaSu
3. Press the buttons ∧+/∨– once to step.
Keep pressing the button to step faster.
Release the button when the required
value is shown in the display. Press SET
to conrm.
Setting the time
1. When the weekday has been set the value
for hours starts ashing..
2. Press ∧+ to increase the value, or ∨– to
decrease.
3. Press ∧+/∨– once to step. Keep pressing
the button to step faster. Release the
button when the required value is shown
in the display. Press SET to conrm.
4. The value for minutes ashes. Set the
minutes in the same way as the hours
above.
Switching to summertime
1. Press at the same time CLOCK and ∨– to
switch to summertime. The time is set
automatically forward 1 hour and S is
shown in the display.
2. Press at the same time CLOCK and ∨– to
switch back to normal time.
NOTE:
The display must be in time mode when
setting the weekday and time. If the display
is in programme settings mode, press the
CLOCK button to switch to time mode.