Anslut 006248 - Programming Timer Schedules; Countdown Timer Function

EN
14
PROGRAMME SETTINGS
1. When the display is in time mode, press
∧+ once to switch to programme settings
mode – 1ON is shown on the bottom left
of the display.
– 1 is the programme number
(possible values are 1 to 14).
– ON indicates weekday and time to
start.
– OFF indicates weekday and time to
stop.
2. Set a higher programme number and
ON or OFF with the button ∧+ as per:
1ON1OFF … 20ON20OFF d ON/
OFF (for countdown).
3. Set a lower programme number and ON
or OFF with the button ∨– as per: ON/OFF
(for countdown)20OFF20ON …
1OFF1ON.
4. Set the required programme number and
then set weekday and time. Press SET until
the weekday ashes. Press repeatedly the
button ∧+. The display changes as per:
– MO TU WE TH FR SA SU
– MOTUWETHFRSASU
– MO WE FR
– TU TH SA
– SA SU
– MO TU WE
– TH FR SA
– MO TU WE TH FR
– MO TU WE TH FR SA
5. Press ∨– to step in the reverse order to the
above.
6. Press ∧+/∨– once to step. Keep pressing
the button to step faster. Release the
button when the required value is shown
in the display. Press SET to conrm.
The displaying of weekday stops ashing.
7. When the weekday has been set the value
for hours starts ashing.. Set the time
as per the instructions in the section for
setting the time.
8. Repeat steps 2 to 7 to set more
programmes.
NOTE:
When the required programme settings are
ready, press CLOCK to return to time mode.
The display returns to time mode after
15 seconds if no buttons are pressed.
SETTING THE COUNTDOWN
1. When the display is in time mode, press
∨– once to switch to countdown settings
mode. d ON (or d OFF) is shown on the
bottom left of the display.
– d indicates that countdown mode is
active
– ON indicates time to start.
– OFF indicates time to stop.
2. Press SET until ON/OFF ashes.
3. Press ∧+/∨– to select ON or OFF and
press SET to conrm.
4. The value for hours ashes. Set the
required value with ∧+/∨– and press SET
to conrm.
5. The value for minutes ashes. Set the
required value with ∧+/∨– and press SET
to conrm.
6. The value for seconds ashes. Set the
required value with ∧+/∨– and press
SET to conrm. The possible values are
99:59:59 seconds to 1 second.
7. Plug the timer into a power point and
set to AUTO mode to start/stop the
countdown function.
8. Press CD once to start the countdown. CD
ashes in the bottom left of the display
to shown that countdown is in progress.
Press CD again to stop the countdown.