Anslut 007018 - Page 65

EN
65
4. RESET
Resets the remote control to default. All the
settings made are lost.
5. Switch
Starts and switches o the air conditioner.
6. FAN SPEED
Switches between speed settings:
AUTO
Low High
7. TIMER ON
Press to activate the setting of start delay. Each
time you press the button the setting increases
in steps of 0.5 hours up to 10 hours and steps
of 1 hour from 10 to 24 hours. Cancel this
function by setting the time to 0.0.
8. ECONOMY (SLEEP)
This function produces a comfortable
temperature and saves energy when you are
sleeping. The function can only be used in
COOL, HEAT and AUTO mode.
NOTE:
If the air conditioner is in ECONOMY mode
this is interrupted if the ON/OFF, FAN SPEED,
ECONOMY or MODE button is pressed.
9. TIMER OFF
Press to activate the setting of stop delay. Each
time you press the button the setting increases
in steps of 0.5 hours up to 10 hours and steps
of 1 hour from 10 to 24 hours. Cancel this
function by setting the time to 0.0.
10. LOCK
Press this depressed button to lock the actual
settings. The remote control does not respond
to pressing any other buttons than LOCK.
This function is used to prevent unintentional
changes. Press the button again to deactivate
the function. When the function is activated
a lock symbol is shown on the display on the
remote control.
11. LED DISPLAY
Press this button to clear the display on the air
conditioner. Press again to activate the display.
FIG. 22
Readings on the display
1. Mode status
Indicates active mode (AUTO, COOL, DRY and
FAN).
2. Reception status
Goes on when the air conditioner receives a
signal from the remote control.
3. Temperature/timer setting
Shows set temperature (17–30°C or 62–88°F)
or timer setting (0–24 hours). Not shown in
FAN mode.
4. ON/OFF
Shown when the air conditioner is running.
5. FAN status mode
6. Fan speed
Shows the selected fan speed (AUTO, HIGH,
MED or LOW). Not shown in AUTO or DRY
mode.
7. TIMER
Shows the timer setting. The TIMER ON status
light goes on if the start delay is activated. The
TIMER OFF status light goes on if the stop delay
is activated. Both status lights go on if both
start delay and stop delay are activated.
8. Locked mode
Shown when the LOCK button is pressed. Goes
o when the LOCK button is pressed again.
FIG. 23