Anslut 007018 - Remote Control Functions; Remote Control Operation and Features

EN
64
Automatic restart
When the power supply is reset after a power
failure the air conditioner restarts with the
previously set function.
START DELAY 3 MINUTES
When the air conditioner has been stopped
it will not start for 3 minutes. This is a safety
function, and is completely normal.
REMOTE CONTROL
• Operating modes: AUTO, COOL, DRY and
FAN
• 24 hour timer.
• Adjustable range for room temperature:
17 to 30°C and 62 to 88°F
NOTE:
• The remote control is intended for
several models and the buttons can
deviate from the actual model.
• If the air conditioner does not have a
specic function nothing will happen
when the corresponding button on the
remote control is pressed.
• The descriptions in the operating
instructions apply before the diagrams
for the remote control.
Positioning
The remote control has a range of 8 metres.
Point the remote control at the receiver on the
air conditioner. An audio prompt conrms the
reception. Doors and curtains etc. can block
the signal on the remote control.
FIG. 20
IMPORTANT:
• Do not expose the remote control to
water or any other liquid. Do not expose
the remote control to heat or direct
sunlight.
• Sunlight or strong articial light can
interfere with the receiver. Protect the
receiver from strong light.
• If the remote control aects other
products in the vicinity, move the
products or contact the retailer.
Replacing the batteries
The remote control has two batteries under a
cover on the back.
1. Open the battery cover.
2. Remove the old batteries and insert new
batteries with the correct polarity.
3. Replace the battery cover.
FIG. 21
IMPORTANT:
• Do not mix old and new batteries, or
dierent types of batteries.
• Remove the batteries if the air
conditioner is not going to be used for 2
months, or more.
• Recycle used batteries in accordance
with local regulations.
• All programmes are deleted when the
batteries are taken out and the remote
control must be reprogrammed.
Functions
1. TEMP DOWN
Reduces the set point temperature in steps of
1°C down to 30 °C, or in steps of 2°F down to
88°F.
2. TEMP UP
Increases the set point temperature in steps of
1°C up to 17 °C, or in steps of 2°F up to 62°F.
3. MODE
Switches between modes in the following
order:
AUTO
COOL DRY FAN