Anslut 417-078 - Troubleshooting

EN
27
TROUBLESHOOTING
Check the following points before contacting your dealer for a service.
Problem Possible cause
The dehumidier will not start. The power cord is not connected properly to the power point.
The fuses have tripped.
The set target humidity has been reached, or the water container is full.
The water container is not properly inserted.
The air is not dehumidifying properly. The dehumidier has not been working long enough.
The air ow to the dehumidier is blocked by furniture or curtains, etc.
The target humidity is set too high.
Doors, windows etc. have not been closed.
The room temperature is too low (lower than 5°C).
Something in the room is emitting moisture.
The dehumidier is making a lot of noise. The air lter is blocked.
The dehumidier is tilted.
The surface is not horizontal.
Frost on the evaporator coils. This is completely normal. The dehumidier defrosts automatically.
Water on the oor. Leakage from the drain hose or connection.
A drain hose has not been connected, and the rubber plug has not been inserted.