Anslut 417-078 - Use; Positioning; Initial Setup; Emptying Water Container

EN
24
Dehumidier parts
1. Control panel
2. Air intake
3. Water container
4. Air lter (inside air intake grille)
5. Handle
6. Air outlet
7. Connection for drainage hose
8. Power cord
9. Plug
10. Power cord holder
USE
Positioning
• Do not use the dehumidier outdoors.
• The dehumidier is only intended for household use. It is not intended for
industrial or commercial use.
• Place the dehumidier on a level, stable surface that can support the
weight of the dehumidier with a full water container.
• Leave at least 20 cm of free space on all sides to ensure the adequate
circulation of air.
• The lowest operating temperature is 5°C. At lower temperatures frost can
form on the evaporator coils, which reduces the performance of the
dehumidier.
• Place the dehumidier at a safe distance from sources of heat.
• Use the dehumidier to ensure a suitable humidity in the air for books or
valuables, and to prevent damage due to damp.
• Only use the dehumidier in enclosed areas.
• Close windows, doors and other openings for maximum eect.
Before using for the rst time
• When using the appliance for the rst time it should be switched on continuously for 24 hours.
• When the dehumidier has been switched o it cannot be started for 3 minutes.
• Connect the dehumidier to a separate power circuit.
• Put the dehumidier in a suitable place and make sure that the mains outlet is easily accessible.
• Only connect the dehumidier to an earthed power point, 220–240 VAC, 50 Hz.
• Check that the water container is properly inserted, otherwise the dehumidier will not work.
EMPTYING THE WATER
The water can drained o in two ways:
Water container
1. The oat switch switches o the dehumidier when the water container is full. The indicator lamp for a full water tank ashes.
2. Carefully pull out the water container. Grip both sides rmly and pull the container straight out. Do not put the container down – the
bottom is uneven and it cannot stand upright.
3. Pour out the water and replace the container. Check that the water container is properly inserted, otherwise the dehumidier will not
work. The dehumidier starts automatically when the water container is replaced.