Deutsch | English | Français | Italiano | Español
Svenska | Português | Nederlands | Russian
13
• Individual call-up of current parameters:
Voltage (V); Capacity (mAh/Ah); Time (hh:mm); Current (mA)
• Multiple overload protection for each rechargeable battery and automatic
termination of the charge process
• Detection of defective rechargeable batteries & detection of alkaline batteries
• Reverse polarity protection
• Pulsed maintenance charging
• Worldwide use (100V-240V)
USE
Different mains plugs may be included, e.g. Euro or UK, depending on the design and
the specific country variant. If the correct plug is not already fitted, position this over
the two contacts of the mains adapter and slide the plug into the guide until it reaches
the stop (see fig. [1]). Ensure that the plug latches into place audibly when sliding on.
Connect the mains adapter with a suitable mains outlet.
To change the mains plug, press the locking tab underneath the plug (e.g. with a pen) in
until it can slide a little upwards and be removed.
OPERATION
Simple charging with preset parameters
1. Insert the rechargeable battery with the correct polarity as shown by the symbol in
the charge bay.
2. After inserting, the indicator in the LCD display flashes. The rechargeable battery
voltage in volts and the preset charge program "CHARGE" are displayed and then
the preset charge current of 600mA is displayed. Then the charge process starts
automatically. Warming of the rechargeable batteries during the charge process is
normal. As soon as the rechargeable battery is fully charged, "FULL" appears in the
display and the rechargeable battery is supplied with maintenance charging. This
function guarantees optimum performance and prevents the self-discharge of the
rechargeable battery. Take out the rechargeable battery and disconnect the product
from the power supply.
3. The USB port serves as a power source with 5V and max. 1A. The USB port and the
charge slots can be used simultaneously.
Advanced functions
The charger has 3 function buttons, "CURRENT", "DISPLAY" and "MODE" (see fig. [2])
which can be used to set the following properties:
To Next Page
Loading...
Need help?
General
