Deutsch | English | Français | Español | Português
Svenska | Italiano | Nederlands
Deutsch | English | Français | Español | Português
Svenska | Italiano | Nederlands
13
PRODUCT DESCRIPTION (SEE PAGE 2)
1 Charging compartment
indicator
2 Rechargeable battery type
3 Charge level
4 END indicator
5 Charging current
6 Timer
7 mAh indicator
8 Voltage indicator
9 Mode
10 USB input
11 Power supply connection
12 MODE button
13 CHANNEL button
14 CURRENT button
15 Charging compartment
16 Charging contact
17 Power supply unit
FUNCTIONS OVERVIEW
• Single-slot monitoring
• Automatic recognition of Li-Ion and NiMH/NiCd rechargeable
batteries
• Automatic charging start when batteries are inserted with correct
polarity
• Micro controller-monitored charge control
• Automatic charging stop for fully charged rechargeable batteries
• Recognition of defective rechargeable batteries
• Display of incorrectly inserted (reverse polarity) rechargeable
batteries
• Detailed status display
• Trickle charge for NiMH rechargeable batteries
• Discharge function and capacity measurement
• Adjustable charging current
• 5 V USB connection, max. 2 A
OPERATION
Simple charging
1. Connect the power supply cable with the power supply connection
on the charger.
2. Connect the power supply to a suitable wall outlet.
3. Slide back the charging contact and insert the rechargeable
battery heeding correct polarity (negative terminal (-) on charging
contact) into the charging compartment.
4. If you do not wish to make any further settings, the product will
begin charging with 500 mA charging current after 8 seconds.
5. Once the rechargeable battery is fully charged, the display will
show the END indicator.
6. Remove the rechargeable battery and disconnect the product from
the power supply.
To Next Page
Loading...
Need help?
General
