Anspach eMax 2 - General Information

2
English
General Information
System Description
High Speed Electric Drill System consisting of consoles, handpieces, foot controls, hand controls, an assortment of
attachments and dissection tools and irrigation accessories.
Indications for Use
Cutting and shaping bone including bones of the cranium and spine.
Contraindications
None.
Cleaning and Sterilization
• Prior to rst use the equipment must be processed as per the included Anspach Cleaning and Sterilization instructions.
• At the point of use the device must be cleaned as soon as possible after use to prevent drying of blood, tissue, other
biological debris and contaminants on the device.
• Refer to the Anspach Cleaning and Sterilization instructions accompanying this device.
Features & Compatibility
Consoles
Foot Control
Features
Hand Controls
SC2100 SC2101 SC2102
Active Direction
Control Switch
Active Irrigation
Control Switch
EMAX2-HC
E-HC
Foot Controls
E-FP • • •
E-FP-DIR • • • •
E-FP-DIR/IRR • • • • •
EPLUS-FP • • • • •
EPLUS-FP-NS • • •
Hand-
pieces
EMAX2PLUS • • • • •
EMAX2 • • • • •
Console
Features
Two Foot Control Ports * •
Two Handpiece Ports * •
Console Irrigation • •
* If two foot controls or two handpieces are connected upon startup of console it will default to Foot Control 1 and/or
Handpiece 1.
The following instructions are written such that the handpiece and attachments are held with distal end pointed away from
user.
Symbols
Anspach Product Icon Consult Operating Instructions
Located on the Foot Pedal switch this indicates
a change state (on/off) for the console Irrigation
System
Located on the Foot Pedal switch this indicates
a change of rotational direction for the
handpiece
Direction of rotation Keep Dry (A.K.A. Protect from Moisture)
Direction of rotation for lock position Indicates position, alignment or location
Indicates setting, position or location AC Power Source
Indicates setting, position or location Indicates position or location
Indicates the attachment setting, refer to MA-
DRIVER & MA-D20 section in this document for
further details
Located on the Console this indicates motor or
handpiece connector