12
Step 4: Once deleted, the LED indicator will be on for 3 seconds
Step 5: Put the dip switch 10 back to the OFF position to start operation
Transmitter battery replacement
If the effective distance seems to decrease, it is possible the battery level is low and
requires replacement. In order to replace the battery, undo the three screws on the back of
transmitter to release the cover. Replace with the same type and specification of battery
which is 27A 12V
Fluid
Only use Antari FLM-05P water-based liquid for the FT-20X Fire
Training Fog Machine. The machine is tested and calibrated with this
liquid to get the best output performance. Warranty will be voided if
any other type of liquid is used. Improper use of liquid may lead to
machine failure or malfunction.
Service and Maintenance
․ Do not allow the machine to become contaminated.
․ Remove dust from air vents with air compressor, vacuum or a soft brush.
․ Only use a damp cloth to clean the casing.
․ Before storing run distilled water through the system to help avoid condensing the
pump or heater.
․ It is recommended to run the machine on a monthly basis in order to achieve best
performance and output condition.
․ Excessive dust, liquid and dirt built up will degrade performance and cause
overheating.
LED Status Indicator
To Next Page
Loading...
