To help avoid accidental exposure to dangerous live AC mains voltage, two
safety screws are fitted that require a screwdriver to remove. Once these are
removed, the finger screws can be undone by hand (see photo above).
Once the screws are removed, the lid of the housing can be carefully swung
upwards, as shown above. Take care not to spill any of the bubble fluid inside
the unit.
The fluid tank is designed to fit only one way around. Make sure you insert it
correctly, as shown above, with the lower edge facing into the machine.
Turn on the power switch located on the back of the W-101 bubble machine.
You will notice that the internal bubble drum and fan are activated. Bubbles are
now produced.
OPERATION
Finger Screw
Safety Screw
To Next Page
Loading...
