EasyManuals Logo

Anthem TLP 1 Specifications

Anthem TLP 1
4 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
PVA 2
PVA 5
PVA 7
(See Dealer for more information)
Optional Rack Kits
Available for most models
INPUTS
PVA 2 . . . . . . . . . . . . . . . . . . . . . . . . 2 Single-Ended, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 4 . . . . . . . . . . . . . . . . . . . . . . . . 4 Single-Ended, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 5 . . . . . . . . . . . . . . . . . . . . . . . . 5 Single-Ended, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 7 . . . . . . . . . . . . . . . . . . . . . . . . 7 Single-Ended, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 8 . . . . . . . . . . . . . . . . . . . . . . . . 8 Single-Ended, 1 Relay Trigger (3.5-mm Mono Jack)
OUTPUTS
PVA 2 . . . . . . . . . . . . . 2 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 4 . . . . . . . . . . . . . 4 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 5 . . . . . . . . . . . . . 5 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 7 . . . . . . . . . . . . . 7 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5-mm Mono Jack)
PVA 8 . . . . . . . . . . . . . 8 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5-mm Mono Jack)
SWITCHES
Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Power On/Off
Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 On/Off Modes (Trigger, Manual, Auto)
THD + N . . . . . . . . . . . . . . . . . . . . . . . . 0.002% at 1 kHz, 0.03% at 20 kHz (125 W into 8 Ω)
POWER OUTPUT
(Continuous RMS, 20 Hz to 20 kHz, <1.0% THD)
Impedance 8 Ω 4 Ω 2 Ω
# of Channels Driven 1 All 1 All 1 All
PVA 2 / 5 / 7 125 W 105 W 200 W 140 W 300 W
PVA 4 125 W 125 W 200 W 165 W 300 W
PVA 8 125 W 90 W 200 W 120 W 300 W
HEADROOM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.25 dB (8 Ω), 2.13 dB (4 Ω)
POWER BANDWIDTH . . . . . . . . . . . . . . . . . . . . . . 10 Hz to 80 kHz (+0 -3 dB) (125 W at 8 Ω)
FREQUENCY RESPONSE . . . . . . 20 Hz to 20 kHz (+0 -0.20 dB), 5 Hz to 100 kHz (+0 -2.5 dB)
INPUT SENSITIVITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.12 Vrms in for 125 W into 8 Ω
INPUT IMPEDANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 kΩ
DAMPING FACTOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 at 1 kHz (ref. 8 Ω)
S/N RATIO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 122 dB, A-weighted (ref. 125 W)
CHANNEL SEPARATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >65 dB (100 Hz to 10 kHz)
VOLTAGE GAIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 dB
SLEW RATE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 V/µs
PVA 2 | 4 | 5 | 7 | 8
TECHNICAL SPECIFICATIONS
Audio measurements were performed with an Audio Precision System Two @ 120 VAC. Specifications and/or features are subject to change without notice as design improvements are incorporated.
POWER REQUIREMENTS
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 105 to 130 V, 60 Hz
Power Consumption (at maximum power output) (8 Ω load)
PVA 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500 W
PVA 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1125 W
PVA 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1125 W
PVA 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1500 W
PVA 8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1500 W
DIMENSIONS (H x W x D; heights include feet)
PVA 2 . . . . . . . . . . . . . 5-7/8˝ (14.9 cm) High x 17-1/4˝ (43.8 cm) Wide x 11˝ (28 cm) Deep
PVA 4 . . . . . . . . 5-7/8˝ (14.9 cm) High x 17-1/4˝ (43.8 cm) Wide x 13-1/4˝ (33.5 cm) Deep
PVA 5 . . . . . . . . 5-7/8˝ (14.9 cm) High x 17-1/4˝ (43.8 cm) Wide x 13-1/4˝ (33.5 cm) Deep
PVA 7 . . . . . . . . . 5-7/8˝ (14.9 cm) High x 17-1/4˝ (43.8 cm) Wide x 16-3/8˝ (42 cm) Deep
PVA 8 . . . . . . . . . 5-7/8˝ (14.9 cm) High x 17-1/4˝ (43.8 cm) Wide x 16-3/8˝ (42 cm) Deep
All Models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Rack-mounting: 3 rack units, without feet
WEIGHT (unpacked)
PVA 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 lb (12 kg)
PVA 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36.1 lb (16.4 kg)
PVA 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36.3 lb (16.5 kg)
PVA 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47.3 lb (21.5 kg)
PVA 8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47.5 lb (21.6 kg)
ADVANCED LOAD MONITORING (ALM)
All Anthem
®
amplifiers are designed to perform flawlessly—offering stunning musicality, tonal
neutrality and incredible dynamics while driving any speaker load reliably under real-world conditions!
The power supply is conservatively rated and the amplifiers run cool for greater reliability, but we
didn’t stop there.
These amplifiers feature our ALM (Advanced Load Monitoring) circuitry which protects
sensitive output devices by constantly monitoring temperature, current and voltage to ensure
optimum long-term performance. ALM is totally non-invasive—it is not in the signal path and
only engages in the most extreme circumstances to protect the amplifier from damage by
maintaining the safe operating area of the output devices. Buyer beware however! Not all
amplifier manufacturers have sophisticated load-monitoring provisions. Many have saved the
added cost, leaving their output devices unprotected, choosing instead to use the amplifier’s
output devices as “fuses.At Anthem, ALM is just one of the ways in which our products
provide owners with years of reliable service.
PVA 4
PVA 8

Other manuals for Anthem TLP 1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Anthem TLP 1 and is the answer not in the manual?

Anthem TLP 1 Specifications

General IconGeneral
BrandAnthem
ModelTLP 1
CategoryAmplifier
LanguageEnglish

Related product manuals