Antx DiaLog Elite - Page 18

DiaLog Elite PLC Interface Manual
To program Elite channel mappings to PLC registers:
What you do: What DiaLog says:
Press
Home
1
PROG
(PROG mode)
“Programming mode activated. System ready.
Enter selection.”
Press
9
(Channel Configuration)
“Channel Configuration. Enter channel number.”
Press 7. 1.
Valid values are:
1 – 5 for function codes (01 – 05)
“The register type is unknown. Press # if OK or
enter a new selection.”
Press 1.
“The new register type is coil. Register number is
0. Press # if OK or enter a new value.”
Press 5. 0. #.
“The new register number is 50. Digital input
channel 71. Enter selection.”
Press #.
“Channel Configuration. Enter channel number”
Press 7. 2.
“The register type is unknown. Press # if OK or
enter a new selection.”
Press 3.
“The new register type is holding. Register number
is 0. Press # if OK or enter a new value.”
Press 1. 2. 1. #.
“The new register number is 121. Analog input
channel 72. Enter selection.”
Press #.
“Channel Configuration. Enter channel number”
Press 7. 3.
“The register type is unknown. Press # if OK or
enter a new selection.”
Press 5.
“The new register type is write coil. Register
number is 0. Press # if OK or enter a new value.”
Press 1. 0. 0. 1. #.
“The new register number is 1001. Relay output
channel 73. Enter selection.”
.
8 Version 1.2 © Antx, inc. 2001