- 10 -
LED LIGHT
NOTE:
It's important to note that there is a delay of approximately 10 seconds
before the inflation process stops after the pressure is displayed as
reaching the preset value on the screen.
Why doesn’t the inflation process stop immediately when the preset tire
pressure is reached?
Our tire inflator is designed to ensure accurate and stable tire pressure.
During the inflation process, there may be slight variations and factors
that can affect the precision, such as the tightness of the air nozzle or
the accuracy of the pressure gauge. To compensate for these potential
errors and guarantee that the tire pressure reaches the desired level, our
tire inflator has a built-in delay mechanism.
First, turn on the power. Then, press and hold the button for 3 seconds to
activate the LED light.
If you want to enter the white light flashing mode, press the button once. To
enter the red-blue light flashing mode, press the button again. If you want to
cycle through the modes, simply press the light button briefly. Finally, to turn off
the LED light, press and hold the light button.
To Next Page