Hotkeys
1 Source / Auto / Exit
2 Eco (DCR / i-Care) / <
3 Volume/ Image Ratio / >
4 Menu / Enter
5 Power
Power
Press the Power button to turn on/off the monitor.
Menu/Enter
Press to display the OSD or confirm the selection.
> Volume
When there is no OSD,Press Volume button to active volume adjustment bar,Press < or > to adjust volume(Only for
the models with speakers). Press and hold the volume > key for 2 seconds to trigger the "image size" adjustment
function to switch among different display modes like wide screen, 4:3, 1:1, 17'' (4:3), 19'' (4:3) W (16:10), 21.5''
(16:9), 22'' W (16:10), and 23'' W (16:9) (if the screen size of the Product is 4:3 or the resolution for the signal input
is in wide screen mode, no 4:3 display mode is available for such key).
< Eco (DCR/i-Care)
Press the Eco key continuously to select the Eco mode of brightness and DCR/I-Care on when there is no OSD.
( Eco mode hot key may not be available in all models).
Source/Auto/Exit
When the OSD is closed, press Source/Auto/Exit button will be auto configure hot key function. When the OSD is
closed, press Source/Auto/Exit button continuously about 3 second to do auto configure (Only for the models with
dual or more inputs).
19
To Next Page
Loading...
Need help?
General
