21.5" LCD Monitor                                                                                                 AOC e2250Swn 
 
Service 
Service 
Service                             
 
                                                                                                                                                                                       
                                                     
                                                             
                                                         
     
 
 
 
Horizontal Frequency 
    30 - 83kHz 
Table of Contents 
Description                         Page    Description                                                    Page 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
   
 
 
 
SAFETY NOTICE   
 ANY PERSON ATTEMPTING TO SERVICE THIS CHASSIS MUST FAMILIARIZE HIMSELF WITH THE   
CHASSIS AND BE AWARE OF THE NECESSARY SAFETY PRECAUTIONS TO BE USED WHEN SERVICING   
ELECTRONIC EQUIPMENT CONTAINING HIGH VOLTAGES. 
Table of Contents…………………..…………………..…...1 
Revision  List.…...................................................……......2   
Important Safety Notice.….….............................……......3 
1.Monitor  Specification..............................………............4                           
2.LCD Monitor Description……….…………………….......5 
3.Operation  Instruction.…………...................……...........6 
3.1.General  Instructions....................................…...........6 
3.2.Control Buttons and Connections...............................6 
3.3.OSD  Setting…..........................................................8 
4.Input/Output pecification...............…..…………….......24 
4.1.Input  Signal  Connector...............………..................24 
4.2.Preset  Display  Modes……..........................25 
4.3.Panel Specification…………..………………………..26 
5.Block  Diagram….........................................................28 
5.1.Main  Board…..….............................................28 
5.2.Power  Board…………..…………………………......29 
6.Schematic…………..….........................................30 
6.1.Main Board..…….…...........................................30 
6.2.Power  Board..……….........................................34 
7.PCB  Layout..………..............................................36 
7.1.Main  Board………..…........................................36 
7.2.Power  Board….…..............................................38 
7.3.Key Board………..…..........................................39 
8.Maintainability………............................................40 
8.1.Equipments and Tools Requirement…...............40 
8.2.Trouble  Shooting…..………...............................41 
9.White-Balance,Luminance  Adjustment…............45 
10.Monitor Exploded View……................................47 
11.BOM List…………..……………………….............48 
CAUTION: USE A SEPARATE ISOLATION TRANSFOMER FOR THIS UNIT WHEN SERVICING 
 
R FOR TH 
 
  UNIT WHEN S