To Next Page

To Previous Page

Wall Mounting

Preparing to Install An Optional Wall Mounting Arm.

This monitor can be attached to a wall mounting arm you purchase separately. Disconnect power before this

procedure. Follow these steps:

1 Remove the base.

2 Follow the manufacturer's instructions to assemble the wall mounting arm.

3 Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in the

back of the monitor.

4 Insert the 4 screws into the holes and tighten.

5 Reconnect the cables. Refer to the user's manual that came with the optional wall mounting arm for

instructions on attaching it to the wall.

Noted : VESA mounting screw holes are not available for all models, please check with the dealer or official

department of AOC.

D-SUB

Other manuals for AOC e2260Swda

Questions and Answers:

Need help?

Do you have a question about the AOC e2260Swda and is the answer not in the manual?

General