To Next Page

To Previous Page

4. Click "Properties" in the "Monitor" tab. If the "Properties" button is deactivated, it means the configuration for your

monitor is completed. The monitor can be used as is.

If the message "Windows needs..." is displayed, as shown in the figure below, click "Continue".

5. Click "Update Driver..." in the "Driver" tab.

6. Check the "Browse my computer for driver software" checkbox and click "Let me pick from a list of device drivers

on my computer".

7. Click on the 'Have disk...' button, then click on the 'Browse...' button and then select the appropriate drive

F:\Driver (CD-ROM Drive).

8. Select your monitor model and click on the 'Next' button.

9. Click "Close" → "Clos e" → "OK" → "OK" on the following screens displayed in sequence.

Other manuals for AOC e2260Swda

Questions and Answers:

Need help?

Do you have a question about the AOC e2260Swda and is the answer not in the manual?

General