19
When there is no OSD and the monitor connect with D-Sub cable, press > continuously to change 4:3 or wide
image ratio. (If the product screen size is 4:3 or input signal resolution is wide format, the hot key is disable to
adjust. )
Auto / Exit
When there is no OSD, press Auto / Exit button continuously about 3 second to do auto configure.
Source hot key
When the OSD is closed, press Source button will be Source hot key function. Press Source button continuously to
select the input source showed in the message bar , press Menu/Enter button to change to the source selected.
Clear Vision
1. When there is no OSD, Press the “<” button to activate Clear Vision.
2. Use the “<” or “>” buttons to select between weak, medium, strong, or off settings. Default setting is always
“off”.
3. Press and hold “<” button for 5 seconds to activate the Clear Vision Demo, and a message of “Clear Vision
Demo: on” will be display on the screen for a duration of 5 seconds. Press Menu or Exit button, the message
will disappear. Press and hold “<” button for 5 seconds again, Clear Vision Demo will be off.
Clear Vision function provides the best image viewing experience by converting low resolution and blurry images
into clear and vivid images.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
