AOC G2460PG - Page 27

27
Timeout
Adjust the OSD
timeout.
5-120
Recall 10
Value
Each step will increase /
decrease value by 5
H. Position
Adjust the horizontal
position of the OSD.
Each step will increase /
decrease value by 25
0-100
Recall
100 Value
V. Position
Adjust the vertical
position of the OSD.
Each step will increase /
decrease value by 5
0-100
Recall 0
Value
Transparence
Adjust the OSD
transparent each step
will increase/decrease
value by 25
0-100
Recall 25
Value
Break
Reminder
Break Reminder if the
user continuely work
for mare than 1 hurs
ON/OFF
Recall
OFF
Value
Note：
1） If turn on, a time break reminder message is generated for each hour (1, 2, 3 ……24 hours, > 24 hours), the
message will be showed for 10 sec. Also, the message will disappear when press any function key.
2）The message location is at the default screen center position and cannot change via OSD.
3）When power on/off, DC on/off, or enter/exit power saving mode, the working time is to clear and recalculate.
4）OSD time out can save data.