42″LCD TV AOC L42H861
1. General Specification
Television System:
NTSC standard
ATSC standard (8-VSB,
Clear-QAM)
HDMI Terminals:
HDMI INPUT: Rear HDMI x2, Side HDMI x1
HDCP compliant
E-EDID compliant
Supported scan rates: 1080P, 1080i, 720p, 480p, 480i
Channel Coverage:
VHF: 2 through 13
UHF: 14 through 69
Cable TV: Mild band (A - 8
through A - 1, A through I )
Super band (J through W)
Hyper band (AA through ZZ,
AAA, BBB)
Ultra band (65 through 94, 100
through 125)
VGA Terminals:
VGA INPUT:
Rear VGA (D-SUB 15 Pin) Input x1
E-EDID compliant
Supported scan rates: 640X480 /60Hz/72Hz/75Hz
720X400 /70Hz
800x600 /56Hz /60Hz /72Hz /75Hz
1024X768 /60Hz/70Hz/75Hz
1920X1080 /60Hz
Recommended: 1920X1080 /60Hz
Audio INPUT: Headphone Mini-jack for stereo (3.5Φ)
Power Source:
AC power supply: 100V~240 V,
50/60 Hz
Audio Output:
AUDIO: 500 mV(rms)
Power Consumption
≤ 250 W
1 W in standby mode (power cord
plugged in and power OFF)
Dimensions:
Include Stand:
1010 mm(W) x 689 mm(H) x 260 mm(L)
Audio Power
10 W + 10 W, Internal Speaker
Video/Audio Terminals:
Rear AV x1:
S-Video/Video/Audio Input
Side AV x1: S-Video/Video/Audio
Input
Wall Mounting:
400x200mm
(Wall mount kit is not included)
S-VIDEO INPUT:
Rear S-Video x 1, Side S-Video x
1
Y : 1 V(p-p), 75 ohm, negative
sync.
C : 0.286 V(p-p) (burst signal), 75
ohm
VIDEO/AUDIO INPUT:
VIDEO: 1 V(p-p), 75 ohm,
negative sync.
AUDIO: 500mV(rms)
Supplied Accessories:
1pcs Power cord
1pcs Remote control
(with two size AAA alkaline batteries)
1pcs User manual
1pcs Setup Guide
Component INPUT:
Rear Component x2:
Y : 1V(p-p), 75 ohm, including
sync.
Pr/Cr: ±0.35V(p-p), 75 ohm
Pb/Cb: ±0.35V(p-p), 75 ohm
AUDIO: 500mV(rms)
Supported resolutions:1080P,
1080i,
720p, ,
480p,
480i
Panel specification:
Active Area: 930.24(H) x 523.26 (V) (42.02” diagonal) mm
Bezel Opening Area: 938.3 (H) x 531.3 (V) mm
river Element: a-si TFT active matrix
Pixel Number: 1920x R.G.B. x 1080 pixel
Pixel Pitch(Sub Pixel): 0.1615 (H) x 0.4845 (V)mm
Pixel Arrangement: RGB vertical str
Display Colors: 16.7M
Display Operation Mode: Transmissive mode / Normally black
Surface Treatment: Anti-Glare coating (Haze 25%)
Hard coating (3H)
Contrast Ratio: 2000 (type) for CR
Response Time: 6.5ms(type) for “Gray to gray”
To Next Page
Loading...
