CONNECTING EQUIPMENT
Coaxial (RF)
Using Your Antenna or Digital Cable for
DTV
.
1. Turn off the power to the HDTV.
2. Connect the coaxial (RF) connector from
your antenna or digital cable (out-of-
the-wall, not from the Cable Box) to the
ANTENNA/CABLE DIGITAL/ANALOG
connector.
3. Turn on the power to the HDTV.
4. Select DTV using the INPUT (SOURCE)
button on the remote, side of the HDTV
or directly by pressing the TV button on
the Remote Control.
Using Your Antenna or Cable for DTV
.
1. Turn off the power to the HDTV.
2. Connect the coaxial (RF) connector from
your antenna or cable (out-of-the-wall, not
from the Cable Box) to the ANTENNA/
CABLE DIGITAL/ANALOG connector at
the rear of the HDTV
3. Turn on the power to the HDTV.
4. Select TV using the INPUT (SOURCE)
button on the remote, side of the HDTV
or directly by pressing the TV button on
the Remote Control.
Using the Antenna or Cable for your
VCR
1. Turn off the power to the HDTV and VCR.
2. Connect the “Output to TV”, “RF Out”
or “Antenna Out” connector on the rear
of your VCR to the ANTENNA/CABLE
DIGITAL/ANALOG connector at the rear
of the HDTV.
3. Turn on the power to the HDTV and VCR.
4. Select TV using the INPUT (SOURCE)
button on the remote, side of the HDTV
or directly by pressing the TV button on
the Remote Control.
NOTE
If you have an off-air antenna or cable TV,
connect it to the “Antenna In” connector
on the rear of your VCR.
To Next Page
Need help?
General
