LM914
8
Preparing To Install The Optional Wall Mount Arm (Not Included)
CONNECTIONS
This monitor can be attached to a wall mounting arm or bracket you can
purchase separately from Ergotron (www.ergotron.com
). Turn the power OFF
then dis-connect the cables from the monitor before performing the procedure
below. Lay the monitor face down on a soft surface.
1. Remove wall mounting hole cover.
2. Remove the cable cover.
3. Remove the 4 screws holding the base to the back of the monitor.
4. Remove the base.
INSTALLATION INSTRUCTIONS (cont)
To Next Page
Loading...
