To Next Page

To Previous Page

Wall Mounting

Preparing to install an optional wall mount arm.

This monitor can be attached to a wall mounting arm you purchase separately. Disconnect power before this

procedure. Follow these steps:

1. Press the base release button to remove base.

2. Use flathead screwdriver to remove the VESA cover.

3. Adjust the tilt angle of the neck to parallel with the display.

4. Assembly the wall mounting arm on the back of the neck with 4 screws.

5. Reconnect the cables. Refer to the user’s manual that came with the optional wall mounting arm for

instructions on attaching it to the wall.

Noted: VESA mounting screws holes are not available for all models. Please check with the dealer or official

department of AOC. Before mounting the monitor on the wall, please find the correct length and size of the screw in

order to avoid the damage of the monitor. The monitor mounting holes shall support 4 mm, 0.7 pitch, and 10 mm in

length screws.

Other manuals for AOC Q2963PM

Questions and Answers:

Need help?

Do you have a question about the AOC Q2963PM and is the answer not in the manual?

General