AODELAN E3+ - Page 15

13
shooting;
2. When the master unit is set to M, slave unit res at the set ash output
3. When the master unit is set to Gr, you can shoot with a different ash
mode (ETTL/M/ OFF)for each group(A/B/C/D/E).
Note:
1) After connecting ash with E3
+
receiver, please rstly turn on the ash,
set the ash mode to ETTL, and lastly turn on the receiver.
2) During wireless shooting, do not operate the ash.
3) E3
+
receiver does not support Multi ash mode.
4) E3
+
receiver does not support Ext.A ash mode.
Setting the Slave Units
1. Setting ring group for save units
Set the ring group for slave units (up to 15 units) accordingly with the setting
of master unit.