AODELAN FT-8 - Test Button; Status LED

Fire All Channels Switch
1. To re all ashes or strobes on receivers set to
different channels press the Fire All Button on the
transmitter.
2. The Channel Numbers 1 to 8 will illuminate.
3. All nearby FT-8 receivers set to any channel in
standby mode will re the connected ashes/
strobes.
4. To turn off Fire All mode press the Fire All Button.
The channel selection will revert to its previous
setting.
Test Button

The Transmitter Test Button will test re remote
ashes/strobes.

To Test: Press the Transmitter Test Button –
ashes/strobes connected to FT-8 receivers on the
same channel will re.
Status LED

The Status LED on the front of the FT-8 transmitter
will ash green approximately every one second
when in standby mode. It will turn red when a
signal is being transmitted.

The Status LED on the front of the FT-8 receiver
will ash green approximately every one second
when in standby mode. It will turn red when a
signal is received from the transmitter.

When battery power is low the Status LED on
the transmitter or receiver will quickly ash red
indicating low power and the need to change
batteries.
• 9 •