AOpen AOW-605 - 10 BASE-T Hub; 100 BASE-TX Hub; Hub Without Uplink (MDI-II) Port; Using Straight Cable

13
straight cable. The connection is accomplished from the
hub uplink (MDI-II) port to any of the Switch (MDI-X) ports:
1x - 5x for the Switch.
A. 10BASE-T Hub
For a 10BASE-T hub, the Switch LED indicators should
light up as the following:
• “ Full-Duplex/Collision” indicator is OFF.
• “100LINK/ACT, 10LINK/ACT LED” indicator is
light amber.
B. 100BASE-TX Hub
For a 100BASE-TX hub, the Switch LED indicators
should light up as the following:
• “ Full-Duplex/Collision” LED indicator is OFF.
• “100LINK/ACT,10LINK/ACT” LED indicator is light
green.
Hub without Uplink (MDI-II) port
If a hub is not equipped with an uplink (MDI-II) port,
connection can be made using either straight cable or
crossover cable.
A. Using straight cable
When using straight cable, the connection can be made
from the uplink (MDI-II) port of the Switch to any port of
the Hub.