8. CARE STORAGE AND BATTERY/CONTROLLER
1.
Clean and Store Electric Scooter
The scooter is designed to be virtually maintenance free, with all parts installed and working
properly, the battery charged, and the tires properly inflated for riding. Do not turn on the
scooter, monitor or motor. These parts are not user serviceable parts.
Make sure the scooter is turned off and unplug the scooter's power supply or charger before
following the procedure below.
a. Check the electric scooter
Be careful with your fingers! Do not grab tires, fenders or wheels.
Because your hands or fingers may be injured, resulting in personalinjury.
b. Maintenance of tires
Tire pressure should be appropriate. Higher pressure reduces suspension performance and
traction, and increase the risk of loss of control, collisions and falls. Lower pressures reduce
the range and increase the risk of tire/wheel assembly damage. To ensure safe and efficient
operation of your scooter, be sure to inspect tires and wheels regularly especially if you have
recently had tire/wheel assembly services.
c. Check the tire/wheel assembly
Check tires and wheels:
1) Make sure the scooter is unplugged and powered off.
2) Wheel assembly Check the wheel rotation and try to move the vehicle. The tire/wheel
assembly should not move laterally. If you detect wheel wobble, check the wheel nuts and
tighten if necessary.
d. Tire pressure
The tires on the scooter provide suspension and traction, both of which are affected by the
tire pressure. When the single tire pressure is too low, please pressurize the tire in time.
Please note the following:
1) Make sure the scooter is unplugged and powered off.
2) Regularly check the tire pressure, improper tire inflation can lead to accidents.
3) If the tire pressure is not at the level specified in "Scooter Specifications" on any tire,
please adjust the tire pressure to the specified pressure.
4) Check that both tires are equally inflated and free of debris or contamination.
e. Clean your scooter
Do not use any specialized cleaners to clean brushes or other corrosives. The use of such
products may reduce friction and increase the risk of slipping.
To clean your scooter:
1) Make sure the scooter is unplugged and powered off.
2) Always close the charging port cover after charging and before cleaning.
3) Gently clean your scooter with soap, water and a soft cloth.
4) Avoid flooding your scooter
To Next Page
Loading...
