aoyue 2738 - OPERATION: SOLDERING IRON; Changing Soldering Iron Temperature; Auto Sleep Mode Shutoff

7
OPERATION
II.SOLDERINGIRONOPERATINGPROCEDURE
A.Changingthetemperaturesetting
1.Turnonthepowerswitch.
2.Pressthebutt on.Makesurethatthesolderingironisattached
properly tothe 5pin output.When error signal beep is heard, press the reset
button.
Thesolderirontemperaturedisplaywillshowthesolderiron’scurrentt emperature,
thistemperaturewillriseto200
O
C.
NOTE:Temperaturecanbesetfrom200  480
o
C.Anincrement/decrementof2
o
C
will be set whenever the temperature adjusting button is pressed.  Press button
steadilyforlargedifferenceindesiredtemperature.
The single heater lamp will blink when the st ation increases and reaches its set
temperature.Noblinkingshallbenoticedwhenthetemperatureisdecreasing.Tip
temperature rises quickly to desired setting.  A beep sound will be heard when
desired temperature has been reached. Temperature drop is dependent on the
surroundingenvironmentandtakestimetocooldown.
B.Autosleepmodeshutoff
Thisisanoptionalsetting.Whenitisactivatedandthe solderingironisnotused
or kept idle for 30 minutes, the power to the heating element will be shutoff
automaticallyandthebuzzerwillbeepthreetimes.Toturnonthefunction
1. In a simultaneous manner,  press UP and DOWN button of the solder iron
temperaturecontroltogether,then
2.Turnonthebuttonwit houtreleasingthepressedbuttons.
3.Thedisplaywillshowindicatingthatthe30minuteidletime sleep
modeisturnedon.
4.After30minutesofidletime,thebuzzerbeepsandthetemperaturedecreasesto
roomtemperature.Whenheatingelementpowerhasbeenshutoff,thedisplay
willshow
Note:Thepowerwillbeturnedonifyouhitanybuttonbeforethetemperature
decreasestoroomtemperature.
5.Tobeginsoldering,pressthebutton.
If t he solder iron reset  button is pressed after setting the auto sleep mode, the
optionwillbevoid.Toturnonthe30minutesleepmodeagain,turnoffthepower
switchandrepeatsteps1&2.
SOLDERIRON
SOLDERIRONRESET
SOLDERIRON