7
Mind the polarity marked on the back of the speaker: + is positive, -
is negative. Most speaker wires have a color code. Respect the color
code starting at your amplifier up to your speakers.
For distances up to 20 meters, you can use 0.75 mm² speaker wire
without any loss of performance. For longer distances, use thicker
wire.
After connecting the speaker wires, use the power selector on the
back to select the correct power setting. This is only applicable
for MASK4T and MASK6T. For low impedance applications select
the 16 Ohm position. Otherwise chose one of the following 100V
power positions.
MASK4T: 2.5 W, 5 W, 10 W, 20 W
MASK6T: 6 W, 15 W, 30 W, 60 W
Once the speaker is connected and in position, place the rubber
protection cover to shield the speaker connections from external
elements.
To Next Page
Loading...
