APC Network Management Card - Setting the network parameters

34003641EN/AF - Page 19
3. Configuration
Via the network
Via Telnet
◗ Check that the card is connected to the ETHERNET network.
◗ Launch the "Run" command under Windows on a PC.
◗ Enter telnet @IP
◗ Connection is made. A screen is displayed.
◗ Enter the password (MGEUPS by default).
◗ The main menu is displayed.
◗ Select one of the items in the configuration menu.
Via a browser
◗ Check that the card is connected to the ETHERNET network.
◗ Run the browser on a PC.
◗ Enter the URL http://@IP/
◗ The main page is displayed.
◗ Select one of the items in the settings menu.
3.3 Setting the network parameters
The Network Management Card requires the following network parameters:
◗ The IP address used for identification on the network.
◗ The Subnet mask which defines the group of users to which it is connected.
◗ The address of the Gateway to which it connects to communicate with another subnet.
The network parameters are set up each time the system is started:
◗ Automatically if the network is equipped with a BOOTP or DHCP server;
◗ With the fixed parameters set manually if an IP address server is not available.
If the BOOTP/DHCP server is not ready, saved parameters are used.