APC Network Management Card - Restoring the default parameters

Page 22 - 34003641EN/AF
3. Configuration
3.5 Restoring the default parameters
If problems occur during the configuration procedure or if the password is lost, it is possible to return to the
default parameters (factory settings), listed in section 1.5.
Via Telnet or Hyper Terminal
◗ Select the "Agent configuration" command by entering 1.
◗ Select the "Reset configuration to default" command by entering 5.
◗ Then follow the instructions on the screen.
Via a browser
◗ Select the "System" command in the configuration menu.
◗ Click the "Factory Reset" button. The IP parameters are kept if the option is selected.
◗ Enter the user name (MGEUPS by default) and the password (MGEUPS by default) if necessary.
Remark. Date and time are not modified after restoring default parameters.